Applied-motion SWM24IP-3EE Manuel d'utilisateur télécharger pdf

Requirements

▪ A 12-70V DC power supply.

▪ A personal computer running Microsoft Windows 98, 2000, ME, NT, XP, Vista or 7 (32 or 64 bit).

▪ ST Conﬁ gurator™ software (available at www.applied-motion.com/products/software).

▪ A 3004-277-5M power cable, 3004-290-5M I/O cable, or a 3004-280-5M Ethernet cable, as needed.

▪ NOTE: Cables are NOT included and must be purchased separately.

▪ For more detailed information, please download and read the SWM24 Hardware Manual, available at www.applied-motion.

com/support/manuals.

To begin, make sure you have the following equipment:

Step 2

a) Download and install the ST Conﬁ gurator™ software.

b) If you intend to connect the drive directly to your PC, conﬁ gure your computer to use IP address 10.10.10.11. (For

instructions on connecting your STM drive to a local area network (LAN), please consult the STM23 Hardware Manual)

c) Do not connect the Ethernet cable to the SWM24 before applying power. This will cause the drive to use its recovery

address, thus assigning itself IP address 10.10.10.10. (See the SWM24 Hardware Manual for further details on

selecting IP addresses for the drive and PC)

d) Launch the software by clicking: Start / All Programs / Applied Motion Products / ST Conﬁ gurator

Step 1

Wire the drive to the DC power source.

(Do not apply power until Step 3)

Note - the SWM24 accepts DC voltages from 12-70V. If using an

external fuse, we recommend a 5 amp fast acting fuse.

(See the SWM24 Hardware Manual for more information about

power supply and fuse selection.)

Connect I/O, if required by your application. A 3004-290-5M

cable will be required.

(See the SWM24 Hardware Manual for more information about

wiring I/O to the SWM24.)

GND

EMI Filter

Power

Input

LINE

LOAD

V+

V-

P/N:092.00823.00 (LCR)

POWER

DC POWER

SUPPLY

V-

V+

V-

GND

920-0070 Rev B

SWM

SWM24 Ethernet Quick Setup

Guide

1 2

SWM24 Ethernet Quick Setup 1

Résumé du contenu

Page 1 - SWM24 Ethernet Quick Setup

Requirements ▪ A 12-70V DC power supply. ▪ A personal computer running Microsoft Windows 98, 2000, ME, NT, XP, Vista or 7 (32 or 64 bit). ▪ ST Conﬁ gu

Page 2

Step 3If you have any questions or comments, please call Applied Motion Products Customer Support:(800) 525-1609, or visit us online at www.applied-mo