Applied-motion STR4 Manuel d'utilisateur télécharger pdf (Page 5)

STR4/8 Hardware Manual

920-0030J

5/12/2015

Jumper S4:

Noise Filter Frequency

Jumper S3:

Step & Direction or

Step CW & Step CCW

Remove connectors

and cover to access

jumpers S3 and S4

Remove Cover and

connectors to access

Jumpers S3 and S4

Geing Started

is manual describes the use of two dierent drive models: the STR4 and STR8. ey dier

in maximum output current and maximum power supply voltage. For both models, you’ll need

the following:

• a24to48voltDCpowersupply(75VmaxforSTR8).Pleasereadthesection

Choosing a

Power Supply

for help in choosing the right power supply.

• oneofthemotorslistedonthedrivelabel(seesection

Conguring the Drive

• asmallatbladescrewdriverfortighteningtheconnectors.

• asourceofstepsignals,suchasaPLCormotioncontroller.

e connectors and other points of interest are illustrated below. ese are detailed later in

the manual.

Motor & Power Supply

Connector

Run Current, Idle Current

Steps/rev, Inertia, Self Test

Input & Output

Signals

Motor Selector

Status LEDs

1 2 3 4 5 6 7 8 9 10 ... 45 46

Pas de commentaire

Applied-motion STR4 Manuel d'utilisateur Page 5